Users Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.2.1.0 Added support for 4093 VLANs on E-Series. Prior releases supported 2094.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information When creating an interface range, interfaces appear in the order they are entered; they are not sorted. The
command verifies that interfaces are present (physical) or configured (logical).
Important Points to Remember:
• Bulk configuration is created if at least one interface is valid.
• Non-existing interfaces are excluded from the bulk configuration with a warning message.
• The interface range prompt includes interface types with slot/port information for valid interfaces. The
prompt allows for a maximum of 32 characters. If the bulk configuration exceeds 32 characters, it is
represented by an ellipsis ( ... ).
• When the interface range prompt has multiple port ranges, the smaller port range is excluded from the
prompt.
• If overlapping port ranges are specified, the port range is extended to the smallest start port and the biggest
end port.
Example (Bulk)
Dell(conf)# interface range gigbitethernet 1/1 - 1/11, tengigabitethernet 3/3,
gigbitethernet 3/10
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example (Multiple
Ports)
Dell(conf)# interface range gigabitethernet 2/10 - 2/23, gigabitethernet 2/12
- 2/17
Dell(conf-if-range-gi-2/10-2/23)#
Example
(Overlapping Ports)
Dell(conf)# interface range gigabitethernet 2/3 - 2/11, gigabitethernet 2/3 -
2/23
Dell(conf-if-range-gi-2/3-2/23)#
Usage Information
Only VLAN and port-channel interfaces created using the interface vlan and interface port-channel
commands can be used in the interface range command.
Use the show running-config command to display the VLAN and port-channel interfaces. VLAN or port-
channel interfaces that are not displayed in the show running-config command cannot be used with the
bulk configuration feature of the
interface range command. You cannot create virtual interfaces (VLAN,
Port-channel) using the interface range command.
NOTE: If a range has VLAN, physical and port-channel interfaces, only commands related to physical
interfaces can be bulk configured. To configure commands specific to VLAN and port-channel only
those respective interfaces should be configured in a particular range.
Interfaces 641