Users Guide

off off off off
off off off off
off on on off
off off off off
off off off off
on off off on
on on on on
on on on on
off off off off
off off off off
on on on on
on on on on
Related Commands
• show running-config — display the flow configuration parameters (non-default values only).
• show interfaces — display the negotiated flow control parameters.
interface
Configure a physical or virtual interface on the switch.
Syntax
interface interface
Parameters
interface Enter one of the following keywords and the interface information:
• For a null interface, enter the keyword null then the slot/port information. The Null
interface number is 0.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a Tunnel interface, enter the keyword tunnel then the tunnel ID. The range is
from 1 to 16383.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a port channel interface, enter the keywords port-channel then a number.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
634 Interfaces