Users Guide

Parameters
milliseconds Enter the interval in milliseconds. The range is from 100 to 65535. The default is 1000
milliseconds.
Defaults 1000 milliseconds
Command Modes INTERFACE VLAN
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information This last-member-query-interval is also the interval between successive Group-Specific Query messages. To
change the last-member-query interval, use this command.
ip igmp snooping mrouter
Statically configure a VLAN member port as a multicast router interface.
Syntax
ip igmp snooping mrouter interface interface
To delete a specific multicast router interface, use the no igmp snooping mrouter interface
interface command.
Parameters
interface interface Enter the following keywords and the interface information:
Internet Group Management Protocol (IGMP) 617