Users Guide

Prompt Interface Type

Dell(conf-if)#

INTERFACE mode

Dell(conf-if-

gi-1/1)#

Gigabit Ethernet interface then the slot/port information

Dell(conf-if-

te-1/1)#

Ten-Gigabit Ethernet interface then slot/port information

Dell(conf-if-

lo-0)#

Loopback interface number

Dell(conf-if-

nu-0)#

Null Interface then zero

Dell(conf-if-

po-0)#

Port-channel interface number The range is from 1 to 128.

Dell(conf-if-

vl-0)#

VLAN Interface then VLAN number (range 1–4094)

Dell(conf-if-

ma-1/1)#

Management Ethernet interface then slot/port information

Dell(conf-if-

tu-0)#

Tunnel interface then tunnel ID.

Dell(conf-if-

range)#

Designated interface range (used for bulk configuration).

IP ACCESS LIST Mode

To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use the ip access-list

standard

command or the ip access-list extended command.

To enter IP ACCESS LIST mode:

1 Verify that you are logged in to CONFIGURATION mode.

2 Enter either the ip access-list standard command or the ip access-list extended command. Include a name for

the ACL. The prompt changes to include

conf-std-nacl or conf-ext-nacl.

You can return to CONFIGURATION mode by using the exit command.

ISIS ADDRESS-FAMILY Mode

To enable or configure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, see Intermediate System to Intermediate

System (IS-IS).

To enter ISIS ADDRESS-FAMILY mode:

1 Verify that you are logged in to ROUTER ISIS mode.

2 Enter the address-family ipv6 unicast command. The prompt changes to include conf-router_isis-af_ipv6.

CLI Basics