Users Guide

redistribute ospf
Redistribute OSPF routes into BGP.
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match internal]]
[route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf process-id command.
Parameters
process-id Enter the number of the OSPF process. The range is from 1 to 65535.
match external {1 |
2}
(OPTIONAL) Enter the keywords match external to redistribute OSPF external
routes. You can specify 1 or 2 to redistribute those routes only.
match internal (OPTIONAL) Enter the keywords match internal to redistribute OSPF internal
routes only.
route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of a configured route map.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced the ability to substitute IGP cost for MED when a peer/peer-group outbound
route-map is set as internal.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
406 Border Gateway Protocol