Users Guide
Version Description
7.7.1.0 Introduced on the C-Series.
Usage Information If you apply a route map to a BGP peer or neighbor with the neighbor default-originate command
configured, the software does not apply the set filters in the route map to that BGP peer or neighbor.
When you configure a route-map for a BGP peer or peer group with the neighbor default-originate
command, the command checks for the existence of the route in BGP RIB.
Route-map configuration on a BGP peer or peer group works only when the LOC-RIB contains at least one route.
When you apply a default route to a BGP peer or peer group using the neighbor default-originate
command, changes to the configured default route-map are applied to the BGP peer or peer group only after a
delay of 15 seconds. As a result, you must wait for a period of 15 seconds before manually resetting BGP using the
clear ip bgp command.
In case of eBGP, the neighbor default-originate command does not support extended-community as a
non-transtive route-map attribute.
You cannot set this configuration for a peer that is associated with a peer group. Similarly, you cannot associate a
peer to a peer group if that peer is already configured with these settings.
In order that settings corresponding to the neighbor default-originate command take effect, you must
execute the clear ip bgp command immediately after you execute the neighbor default-originate
command.
neighbor description
Assign a character string describing the neighbor or group of neighbors (peer group).
Syntax
neighbor {ip-address | peer-group-name} description text
To delete a description, use the no neighbor {ip-address | peer-group-name} description
command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
text Enter a continuous text string up to 80 characters.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
380 Border Gateway Protocol