Users Guide

Version Description
7.2.1.0 Introduced.
Usage Information
This command turns on BGP soft-reconfiguration inbound debugging. If no neighbor is specified, debug turns on
for all neighbors.
debug ip bgp updates
Allows you to view information about BGP updates.
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group peer-group-name]
updates [in | out | prefix-list prefix-list-name]
To disable debugging, use the no debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X |
peer-group peer-group-name] updates [in | out | prefix-list prefix-list-name]
command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to view BGP
updates information corresponding to that VRF.
A.B.C.D (OPTIONAL) Enter an IPv4 address of the neighbor.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group peer-
group-name
(OPTIONAL) Enter the keyword peer-group followed by the name of the peer group.
in (OPTIONAL) Enter the keyword in to view only BGP updates received from neighbors.
out (OPTIONAL) Enter the keyword out to view only BGP updates sent to neighbors.
prefix-list prefix-
list-name
(OPTIONAL) Enter the keyword prefix-list then the name of an established prefix
list. If the prefix list is not configured, the default is permit (to allow all routes).
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name (OPTIONAL) Enter the name of the peer group to disable or enable all routers within the
peer group.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
Border Gateway Protocol 371