Users Guide

Usage Information
To view information on both incoming and outgoing routes, do not include the in and out parameters in the
debugging command. The in and out parameters cancel each other; for example, if you enter the debug ip
bgp in
command and then enter the debug ip bgp out command, you do not see information on the
incoming routes.
Entering a no debug ip bgp command removes all configured debug commands for BGP.
Related Commands
• debug ip bgp events — view information about BGP events.
• debug ip bgp keepalives — view information about BGP keepalives.
• debug ip bgp notifications — view information about BGP notifications.
• debug ip bgp updates — view information about BGP updates.
• show debugging — view enabled debugging operations.
debug ip bgp dampening
View information on routes being dampened.
Syntax
debug ip bgp [vrf vrf-name] [ipv4 {unicast | multicast} | ipv6 unicast]
dampening
To disable debugging, use the no debug ip bgp dampening command.
Parameters
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to view information on
dampened routes corresponding to that VRF.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to view
dampened-route information related only to ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to view
dampened-route information related only to ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword unicast to view
dampened-route information related only to ipv6 unicast routes.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
366 Border Gateway Protocol