Users Guide

seq
To a deny or permit filter in a prefix list while configuring the filter, assign a sequence number.
Syntax
seq sequence-number {deny | permit} {any} | [ip-prefix /nn {ge min-prefix-
length} {le max-prefix-length}] | [bitmask number]
To delete a specific filter, use the no seq sequence-number {deny | permit} {any} | [ip-
prefix {ge min-prefix-length} {le max-prefix-length}] | [bitmask number].
Parameters
sequence-number Enter a number. The range is from 1 to 4294967294.
deny Enter the keyword deny to configure a filter to drop packets meeting this condition..
permit Enter the keyword permit to configure a filter to forward packets meeting this
condition.
any (OPTIONAL) Enter the keyword any to match any packets.
ip-prefix /nn (OPTIONAL) Specify an IP prefix in the network/length format. For example, 35.0.0.0/8
means match the first 8 bits of address 35.0.0.0.
ge min-prefix-
length
(OPTIONAL) Enter the keyword ge and then enter the minimum prefix length, which is a
number from zero (0) to 32.
le max-prefix-
length
(OPTIONAL) Enter the keyword le and then enter the maximum prefix length, which is a
number from zero (0) to 32.
bitmask number Enter the keyword bitmask then enter a bit mask number in dotted decimal format.
Defaults Not configured.
Command Modes PREFIX-LIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
236 Access Control Lists (ACL)