Users Guide

Related Commands
• deny — configure a MAC ACL filter to drop packets.
• seq — configure a MAC ACL filter with a specified sequence number.
IP Prefix List Commands
When you create an access-list without any rule and then apply it to an interface, the ACL behavior reflects implicit permit.
To configure or enable IP prefix lists, use these commands.
clear ip prefix-list
Reset the number of times traffic mets the conditions (“hit” counters) of the configured prefix lists.
Syntax
clear ip prefix-list [prefix-name]
Parameters
prefix-name (OPTIONAL) Enter the name of the configured prefix list to clear only counters for that
prefix list, up to 140 characters long.
Defaults Clears “hit” counters for all prefix lists unless a prefix list is specified.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Increase the name string to accept up to 140 characters. Prior to 7.8.1.0, names were up
to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Related Commands
• ip prefix-list — configure a prefix list.
Access Control Lists (ACL) 233