Users Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Added the keyword dscp.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
8.1.1.0 Introduced on the E-Series.
7.4.1.0 Added support for non-contiguous mask and added the monitor option.
6.5.1.0 Expanded to include the optional QoS order priority for the ACL entry.
Usage Information
The order option is relevant in the context of the Policy QoS feature only. For more information, see the Quality
of Service section of the Dell Networking OS Configuration Guide.
The monitor option is relevant in the context of flow-based monitoring only. For more information, see Port
Monitoring
.
deny tcp
Configure a filter that drops transmission control protocol (TCP) packets meeting the filter criteria.
Syntax
deny tcp {source mask | any | host ip-address} [bit] [operator port [port]]
{destination mask | any | host ip-address} [dscp] [bit] [operator port [port]]
[count [bytes] [order] [fragments] [monitor [session-ID]] [no-drop]
To remove this filter, you have two choices:
Use the no seq sequence-number command if you know the filter’s sequence number.
Use the no deny tcp {source mask | any | host ip-address} {destination mask |
any | host ip-address} command.
Parameters
source Enter the IP address of the network or host from which the packets are sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in
A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
dscp Enter this keyword dscp to deny a packet based on the DSCP value. The range is from 0
to 63.
bit Enter a flag or combination of bits:
ack: acknowledgement field
fin: finish (no more data from the user)
psh: push function
rst: reset the connection
syn: synchronize sequence numbers
urg: urgent field
Access Control Lists (ACL) 201