Users Guide

show dot1x interface
Display the 802.1X configuration of an interface.
Syntax
show dot1x interface interface [mac-address mac-address]
Parameters
interface Enter one of the following keywords and the interface information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
mac-address (Optional) MAC address of a supplicant.
Defaults None
Command Modes
• EXEC
• EXEC privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.4.2.1 Added the mac-address option on the C-Series and S-Series.
7.6.1.0 Introduced on the C-Series, E-Series, and S-Series.
Usage Information
If you enable 802.1X multi-supplicant authentication on a port, additional 802.1X configuration details (Port
Authentication status, Untagged VLAN ID, Authentication PAE state, and Backend state) display for each
supplicant, as shown in the following example.
Example
Dell# show dot1x interface gigabitethernet 1/32
802.1x information on Gi 1/32:
-----------------------------
Dot1x Status: Enable
802.1X 177