Users Guide

Version Description
9.10(0.0) Introduced on the S3100 series, S4048–ON, S4048–ON, S4810, S4820T, S5000, S6000,
S6000–ON, the Configuration Terminal Batch mode on C9010, Z9100–ON, and Z9500.
9.9(0.0) Introduced on the C9010.
Usage Information
The mac command configures a list of supplicant MAC addresses for a dot1x profile represented with a profile-
name. You can configure up to 6 MAC addresses in a single mac command. The maximum number of MAC
addresses that you can configure in a single profile is limited to 100.
Use this command in Configuration Terminal Batch mode to configure a list of supplicant MAC addresses for dot1x
profile in a dual-homing setup.
Example
Dell(conf)#dot1x profile mySupplicants
Dell(conf-dot1x-profile)#mac 00:50:56:AA:01:10 00:50:56:AA:01:11
Dell(conf-dot1x-profile)#show config
dot1x profile mySupplicants
mac 00:50:56:aa:01:10
mac 00:50:56:aa:01:11
Dell(conf-dot1x-profile)#
Dell(conf-dot1x-profile)#exit
show dot1x cos-mapping interface
Display the CoS priority-mapping table the RADIUS server provides and applies to authenticated supplicants on an 802.1X-enabled system.
Syntax
show dot1x cos-mapping interface interface [mac-address mac-address]
Parameters
interface Enter one of the following keywords and the interface information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
mac-address (Optional) MAC address of an 802.1X-authenticated supplicant.
Defaults None
Command Modes
• EXEC
• EXEC privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
802.1X 175