Users Guide

Version Description
6.2.1.1 Introduced on the E-Series.
Usage Information
NOTE: This command also enables you to clear the port configurations corresponding to a range of
ports. However, for Open Networking (ON) platforms the notation for specifying port range in the
command is different from how you specify in non-ON platforms.
• For non-ON platforms, you can specify multiple ports as slot/port-range. For example, if you want
to clear the port configurations corresponding to all ports between 1 and 4, specify the port range as
clear counters interfaces interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/[subport] - slot/port/
[subport]. For example, if you want to clear the port configurations corresponding to all ports
between 1 and 4, specify the port range as clear counters interfaces interface-type
1/1/1 - 1/1/4.
debug vrrp
Enable VRRP debugging.
Syntax
debug vrrp [vrrp-id] {all | bfd | database | interface | ipv6 | packets | state
| timer}
To disable debugging, use the no debug vrrp [vrrp-id] {all | bfd | database | interface
| ipv6 | packets | state | timer} command.
Parameters
vrrp-id (OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all Enter the keyword all to enable debugging of all VRRP groups.
bfd Enter the keyword bfd to enable debugging of VRRP BFD interactions.
database Enter the keyword database to enable debugging of configuration changes.
interface Enter the following keywords and the interface information:
• For Port Channel interface types, enter the keywords port-channel then the
number.
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID
range is from 1 to 4094.
interface Enter the keyword interface to enable debugging of interface state changes.
ipv6 Enter the keyword ipv6 to enable debugging for IPv6.
packets Enter the keyword packets to enable debugging of VRRP control packets.
state Enter the keyword state to enable debugging of VRRP state changes.
timer Enter the keyword timer to enable debugging of the VRRP timer.
Command Modes EXEC Privilege
1676 Virtual Router Redundancy Protocol (VRRP)