Users Guide

To disable unknown-unicast storm control on the interface, use the no storm-control unknown-unicast
[percentage decimal_value in] | [wred-profile name]] [packets_per_second in]
command.
Parameters
percentage
decimal_value [in |
out]
E-Series Only: Enter the percentage of broadcast traffic allowed in or out of the network.
Optionally, you can designate a decimal value percentage, for example, 55.5%.
The percentage is from 0 to 100:
• 0% blocks all related traffic.
• 100% allows all traffic into the interface.
The decimal range is from 0.1 to 0.9.
wred-profile name E-Series Only: (Optionally) Enter the keywords wred-profile followed by the profile
name to designate a wred-profile.
packets_per_secon
d in
C-Series and S-Series Only: Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554431.
Defaults none
Command Modes INTERFACE (conf-if-interface-slot/port)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 E-Series Only: Added the percentage decimal value option.
6.5.1.0 Introduced on the E-Series.
Storm Control 1545