Users Guide

Version Description
8.2.1.0 Introduced on S-Series Stacking.
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information This command changes the sampling rate for an interface. By default, the sampling rate of an interface is set to
the same value as the current global default sampling rate. If the value entered is not a correct power of 2, the
command generates an error message with the previous and next power-of-2 value. Select one of these two
number and re-enter the command.
Related Commands
• sflow sample-rate (Global) — changes the sampling rate globally.
show sflow
Display the current sFlow configuration.
Syntax
show sflow [interface]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For the Management interface on the, enter the keyword ManagementEthernet
then the slot/port information.
• For a port-channel interface, enter the keywords port-channel then the port-
channel ID.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
1470 sFlow