Users Guide

Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added the DSCP Marking option support on the S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series; added support for the DSCP Marking option.
6.1.1.1 Introduced on the E-Series.
Usage Information To access this command, enter the class-map command. After the class map is identified, you can configure
the match criteria. For class-map match-any, a maximum of five ACL match criteria are allowed. For class-map
match-all
, only one ACL match criteria is allowed.
Related Commands
• class-map — identifies the class map.
match ip dscp
Use a differentiated services code point (DSCP) value as a match criteria.
S3048–ON
Syntax
match {ip | ipv6 | ip-any} dscp dscp-list [set-ip-dscp value]
To remove a DSCP value as a match criteria, use the no match {ip | ipv6 | ip-any} dscp dscp-
list [[multicast] set-ip-dscp value] command.
Parameters
ip Enter the keyword ip to support IPv4 traffic.
ipv6 Enter the keyword ipv6 to support IPv6 traffic.
ip-any Enter the keyword ip-any to support IPv4 and IPv6 traffic.
Quality of Service (QoS) 1251