Users Guide

Dell(conf-pvst)#
Dell(conf-pvst)# show config
!
protocol spanning-tree pvst
no disable
vlan 2 bridge-priority 4096
vlan 3 bridge-priority 16384
Dell#
Usage Information After you enable PVST+, the device runs an STP instance for each VLAN it supports.
Related Commands
• disable — disables PVST+.
• show spanning-tree pvst — displays the PVST+ configuration.
show spanning-tree pvst
View the Per-VLAN spanning tree configuration.
S3048
Syntax
show spanning-tree pvst [vlan vlan-id] [brief] [guard]
Parameters
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID. The range is 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a synopsis of the PVST+ configuration
information.
interface (OPTIONAL) Enter one of the interface keywords along with the slot/port information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
•
For a Port Channel interface, enter the keyword port-channel then a number:
guard (OPTIONAL) Enter the keyword guard to display the type of guard enabled on a PVST
interface and the current port state.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Per-VLAN Spanning Tree Plus (PVST+) 1227