Users Guide

Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the S-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information First-hop routers use this address by to send register packets on behalf of source multicast hosts. The RP
addresses are stored in the order in which they are entered. The RP is chosen based on a longer prefix match for a
group. The RP selection does not depend on dynamic or static RP assignments.
ip pim rp-candidate
Configure a PIM router to send out a Candidate-RP-Advertisement message to the bootstrap (BS) router or define group prefixes that are
defined with the RP address to PIM BSR.
Syntax
ip pim [vrf vrf-name] rp-candidate {interface [priority] [acl-name]}
To return to the default value, use the no ip pim [vrf vrf-name] rp-candidate {interface
[priority]} command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default
VRF.
interface Enter the following keywords and slot/port or number information:
For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
For a port-channel interface, enter the keywords port-channel then the port-
channel ID.
For a VLAN, enter the keyword vlan then a number from 1 to 4094.
priority (OPTIONAL) Enter the priority used in Bootstrap election process. The range is zero (0)
to 255. The default is 192.
acl-name (OPTIONAL) Enter the name of an ACL to configure a PIM router to act as an RP for a
specific set of multicast group addresses that are defined in the ACL.
Defaults Not configured.
Command Modes CONFIGURATION
PIM-Sparse Mode (PIM-SM) 1187