Users Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.6.1.0 Introduced
Usage Information The access name is an extended IP access list that denies PIM register packets to RP at the source DR based on
the multicast and group addresses. Do not enter this command before creating the access-list.
ip pim rp-address
Configure a static PIM rendezvous point (RP) address for a group or access-list.
Syntax
ip pim [vrf vrf-name] rp-address address {group-address group-address mask}
[override]
To remove an RP address, use the no ip pim [vrf vrf-name] rp-address address {group-
address group-address mask} [override] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default
VRF.
address Enter the RP address in dotted decimal format (A.B.C.D).
group-address
group-address
mask
Enter the keywords group-address then a group-address mask, in dotted decimal
format (/xx), to assign that group address to the RP.
override Enter the keyword override to override the BSR updates with static RP. The override
takes effect immediately during enable/disable.
NOTE: This option is applicable to multicast group range.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
1186 PIM-Sparse Mode (PIM-SM)