Users Guide

Policy-based Routing (PBR)

Policy-based routing (PBR) allows you to apply routing policies to specific interfaces. To enable PBR, create a redirect list and apply it to

the interface. After the redirect list is applied to the interface, all traffic passing through the interface is subject to the rules defined in the

redirect list. PBR is supported by the Dell Networking OS.

You can apply PBR to physical interfaces and logical interfaces (such as a link aggregation group [LAG] or virtual local area network

[VLAN]). Trace lists and redirect lists do not function correctly when you configure both in the same configuration.

NOTE: Apply PBR to Layer 3 interfaces only.

NOTE: For more information , see Content Addressable Memory (CAM).

Topics:

• description

• ip redirect-group

• ip redirect-list

• permit

• redirect

• seq

• show cam pbr

• show ip redirect-list

description

Add a description to this redirect list.

Syntax

description {description}

To remove the description, use the no description {description} command.

Parameters

description Enter a description to identify the IP redirect list (16 characters maximum).

Defaults None

Command Modes REDIRECT-LIST

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking

OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100-ON.

1166 Policy-based Routing (PBR)