Users Guide

Defaults
• start-interval: 0 msec
• hold-interval: 5000 msec
• max-interval: 5000 msec
Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
9.0.2.0 Introduced on the S6000..
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Usage Information LSAs are sent after the start-interval and then after hold-interval until the maximum interval is reached. In
throttling, exponential backoff is used when sending same LSA, so that the interval is multiplied until the maximum
time is reached. For example, if the start-interval 5000 and hold-interval 1000 and max-interval 100,000, the LSA
is sent at 5000 msec, then 1000 msec, then 2000 msec, them 4000 until 100,000 msec is reached.
timers throttle lsa arrival
Configure the LSA acceptance intervals.
Syntax
timers throttle lsa arrival arrival-time
To return to the default, use the no timers throttle lsa command.
Parameters
arrival-time Set the interval between receiving the same LSA repeatedly, to allow sufficient time for
the system to accept the LSA. The range is from 0 to 600,000 milliseconds.
Defaults 1000 msec
Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Open Shortest Path First (OSPFv2 and OSPFv3) 1129