Users Guide

Parameters
number Specify the number of paths. The range for OSPFv2 is from 1 to 64. The default for
OSPFv2 is 4 paths. The range for OSPFv3 is from 1 to 64. The default for OSPFv3 is 8
paths.
Defaults 4
Command Modes ROUTER OSPF for OSPFv2
ROUTER OSPFv3 for OSPFv3
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.1(0.0) Introduced support for OSPFv3 on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
network area
Define which interfaces run OSPF and the OSPF area for those interfaces.
S3048–ON
Syntax
network ip-address mask area area-id
To disable an OSPF area, use the no network ip-address mask area area-id command.
Parameters
ip-address Specify a primary or secondary address in dotted decimal format. The primary address is
required before adding the secondary address.
mask Enter a network mask in /prefix format. (/x)
Open Shortest Path First (OSPFv2 and OSPFv3) 1085