Administrator Guide

Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
advertise interface-port-desc
Advertise port descriptor.
Syntax
advertise interface-port-desc {description | port-id}
To remove the advertised port descriptor, use the no advertise interface—port—desc
{description | port-id} command.
Parameters
description Enter the keyword description then the interface description.
port-id Enter the keyword port-id then the port-id. The range is from 0 to 7.
Defaults None
Command Modes
CONFIGURATION (conf-lldp)
INTERFACE (conf-if-interface-lldp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(2.0P1) Introduced the description and port-id options.
Usage
Information
If you do not specify the option, by default the port-id takes higher precedence and sends the port-id in
the LLDP packets.
advertise management-tlv
Advertise management TLVs (Type, Length, Value).
Syntax
advertise management-tlv {management-address | system-capabilities |
system-description | system-name}
To remove advertised management TLVs, use the no advertise management-tlv
{management-address | system-capabilities | system-description | system-
name} command.
Parameters
management-
address
Enter the keyword management-address to advertise the management IP address
TLVs to the LLDP peer.
system-
capabilities
Enter the keywords system-capabilities to advertise the system capabilities
TLVs to the LLDP peer.
Link Layer Discovery Protocol (LLDP) 909