Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

891

892

893

894

895

896

897

898

899

900

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.12.0 Introduced on the S4810.

Usage

Information

When you enter no fefd for an interface and fefd-global, FEFD is enabled on the interface

because the no fefd command is not retained in the configuration file. To keep the interface FEFD

disabled when the global configuration changes, use the fefd reset command.

Commands

● fefd disable — disable far-end failure detection on an interface.

● fefd reset — enable FEFD globally on the system.

● fefd mode — change FEFD mode on an interface.

fefd disable

Disable FEFD on an interface only. This command overrides the fefd reset command for the interface.

Syntax