Administrator Guide

crypto ipsec policy
Create a crypto policy used by ipsec.
Syntax
crypto ipsec policy name seq-num ipsec-manual
To delete a crypto policy entry, use the no crypto ipsec policy name seq-num ipsec-
manual command.
Parameters
name Enter the name for the crypto policy set.
seq-num Enter the sequence number assigned to the crypto policy entry.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
9.2(1.0) Introduced on the Z9500.
Usage
Information
This command creates a crypto policy entry and enters the crypto policy configuration mode for
configuring the flow parameters.
Example
Dell(conf)# crypto ipsec policy West 10 ipsec-manual
Dell(conf-crypto-policy)#
management crypto-policy
Apply the crypto policy to management traffic.
Syntax
management crypto-policy name
To remove the management traffic crypto policy, use the no management crypto-policy name
command.
Parameters
name Enter the name for the crypto policy..
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
700 Internet Protocol Security (IPSec)