Administrator Guide

Version Description
9.11(0.0) Added support to display 10GBASE-T information on the S4048, S4048T, S6000,
S6000-ON, S6100, Z9500, S6010, and Z9100.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.9(0.0) Added support to display the interface configurations corresponding to a range of
ports.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Output augmented with diagnostic data for pluggable media.
7.7.1.0 Removed three fields in the output: Vendor Name, Vendor OUI, and Vendor PN.
7.6.1.0 Introduced on the C-Series and S-Series.
6.5.4.0 Introduced on the E-Series.
Usage
Information
The following describes the columns displayed in the output of the show interfaces transceiver
command:
Line Description
Rx Power
measurement
type
Output depends on the vendor, typically either “Average” or “OMA” (Receiver
optical modulation amplitude).
Tx Power
measurement
type
Output depends on the vendor, typically either “Supported” or “Not supported”.
Temp High Alarm
threshold
Factory-defined setting, typically in Centigrade. Value differs between SFPs and
SFP+.
Voltage High
Alarm threshold
Displays the interface index number used by SNMP to identify the interface.
Bias High Alarm
threshold
Factory-defined setting. Value can differ between SFP and SFP+.
TX Power High
Alarm threshold
Factory-defined setting. Value can differ between SFP and SFP+.
RX Power High
Alarm threshold
Factory-defined setting. Value can differ between SFP and SFP+.
Temp Low Alarm
threshold
Factory-defined setting. Value can differ between SFP and SFP+.
Interfaces 667