Administrator Guide

Version Description
9.9(0.0) Added support to display the interface configurations corresponding to a range of
ports.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced
Example
DellEMC# show interfaces dampening
Interface Supp Flaps Penalty Half-Life Reuse Suppress Max-Sup
State
Gi 1/2 Up 0 0 20 800 4500 120
Gi 1/10 Up 0 0 5 750 2500 20
DellEMC#
Related
Commands
● dampening — configure dampening on an interface.
● show interfaces configured — display any interface with a non-default configuration.
show interfaces eee
Display whether EEE is enabled on interfaces..
Syntax
show interfaces [interface—type [slot/port | slot/port-range]] eee
Parameters
interface-type Enter the interface information as TenGigabitEthernet followed by the slot
and the port number or range of port numbers.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(0.0) Introduced on the S3048–ON.
9.10(0.1) Introduced on the S3100 series, S4820T, and S5000.
Usage
Information
The show interfaces eee command displays whether EEE has been enabled and shows the status
of all the interfaces.
658 Interfaces