Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

621

622

623

624

625

626

627

628

629

630

Defaults Not configured.

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.4(0.0) Added the support for interfaces.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.5.1.0 Added support for 4-port 40G line cards on the E-Series.

8.1.1.0 Introduced on the E-Series.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.4.1.0 Introduced

Usage

Information

You cannot delete a physical interface.

By default, physical interfaces are disabled (shutdown) and are not assigned to an IP address or

switchport. To place an interface in Layer 2 mode, ensure that the interface’s configuration does not

contain an IP address and enter the switchport command.

You can create up to 64 tunnel interfaces. The tunnel is added as a logical interface with no default

configuration. To delete a tunnel interface, use the no interface tunnel tunnel-id command.

The tunnel interface operates as an ECMP (equal cost multi path) only when the next hop to the tunnel

destination is over a physical interface. If you select any other interface as the next hop to the tunnel

destination, the tunnel interface does not operate as an ECMP.

Example

DellEMC(conf)# int tengigabitethernet 1/10

DellEMC(conf-if-gi-1/10)# exit

DellEMC(conf)#

Commands

● interface loopback — configure a Loopback interface.

● interface null — configure a Null interface.

● interface port-channel — configure a port channel.

● interface vlan — configure a VLAN.

624 Interfaces