Administrator Guide

errdisable recovery interval
Configure recovery time interval to move an interface from the Err-disabled state.
Syntax
errdisable recovery interval seconds
To remove the configured recovery time interval, use the no errdisable recovery interval
seconds command.
Parameters
interval seconds Enter the keyword interval and the number of seconds to recover the interface
from Err-disabled state. The range is from 30 to 86,400 seconds. The default is
300 seconds.
Defaults 300 seconds.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the platforms S4048–ON, S6100–ON, Z9100–ON, S4048T-ON,
S3048–ON, S6000, S6010–ON, S5048F-ON, FN-IOM, and MXL.
9.13(0.2P2) Introduced on the S3100.
Usage
Information
Whenever the Err-disable recovery timer is reconfigured, it will get effective only after the current timer
expires. Following message is displayed after each Err-disable recovery timer configuration:
DellEMC(conf)# errdisable recovery interval 30
New timer interval will be effective from the next timer instance only.
Related
Commands
errdisable recovery cause — Enable automatic recovery of an interface from the error disabled state.
eee
Enable Energy-Efficient Ethernet (EEE) on native or optional module copper ports.
Syntax
eee
To disable EEE, use the no eee command.
Defaults None.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(0.) Introduced on the S3048–ON.
9.10(0.1) Introduced on the S4820T and S5000.
9.10(0.0) Introduced on the S3100 series.
Usage
Information
EEE is an IEEE 802.3 az standard that reduces power consumptions on Ethernet ports. When EEE is
enabled, transmission is stopped when there is no data to be transmitted and is resumed on arrival of new
packets. You can enable EEE only on ten Gigabit native or optional module copper ports.
620 Interfaces