Manualshelf

Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON
581582583584585586587588589590
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the E-Series.
Related
Commands
● show lacp — display the lacp configuration.
● show redundancy — display the current redundancy configuration.
show redundancy
Display the current redundancy configuration.
Syntax
show redundancy
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show redundancy command shown in the following example.
Field Description
RPM Status Displays the following information:
● Slot number of the RPM.
● Whether the RPM is Primary or Standby.
● The state of the RPM: Active, Standby, Booting, or Offline.
● Whether the link to the second RPM is up or down.
High Availability (HA) 583