Administrator Guide

hardware-address
For manual configurations, specify the client hardware address.
Syntax
hardware-address address
Parameters
address Enter the hardware address of the client.
Defaults None
Command Modes DHCP <POOL>
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
host-address
For manual (rather than automatic) configurations, assign a host to a single-address pool.
Syntax
host—address address
Parameters
address Enter the host IP address.
Defaults None
Command Modes DHCP-POOL
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14.1.3 This command replaces host command. Introduced on S3048–ON, S4048–ON,
S4048T-ON, S6000–ON, S6010–ON, S6100–ON, Z9100–ON, S3100, S6000,
S4810, S4820T, S5048F-ON, MXL, FN-IOM, and C9010.
508 Dynamic Host Configuration Protocol (DHCP)