Administrator Guide

To disable next-hop resolution, use the no bgp recursive-bgp-next-hop command.
Defaults Enabled
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced.
Usage
Information
This command is a knob to disable BGP next-hop resolution using BGP learned routes. During the next-
hop resolution, only the first route that the next-hop resolves through is verified for the route’s protocol
source and is checked if the route is learned from BGP or not.
The clear ip bgp command is required for this command to take effect and to keep the BGP
database consistent. Execute the clear ip bgp command right after executing this command.
Related
Commands
● clear ip bgp — clear the ip bgp.
bgp redistribute-internal
Redistribute internal Border Gateway Protocol (iBGP) routes into and IGP such as OSPF and IS-IS.
Syntax
bgp redistribute-internal
To disable iBGP redistribution, use the no bgp redistribute-internal command.
Defaults Not configured.
Command Modes
● ROUTER BGP
● ROUTER BGP-address-family
● ROUTER BGP-address-family-IPv6
● IPv4 VRF mode
● IPv6 Unicast VRF mode
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
360 Border Gateway Protocol