Administrator Guide

mac
Configure a list of supplicant MAC addresses for dot1x profile represented with a profile-name.
Syntax
[no] mac {mac-address1 mac-address2… mac-address6}
Parameters
mac-address1
mac-address2 …
mac-address6
Enter the keyword mac and type the 48– bit MAC addresses using the H.H.H
format. A maximum of 6 MAC addresses are allowed.
Defaults None
Command Modes
DOT1X PROFILE CONFIG (conf-dot1x-profile)
CONFIGURATION TERMINAL BATCH
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S3100 series, S4048–ON, S4048–ON, S4810, S4820T, S5000,
S6000, S6000–ON, S6100–ON, the Configuration Terminal Batch mode on C9010,
Z9100–ON, and Z9500.
9.9(0.0) Introduced on the C9010.
Usage
Information
The mac command configures a list of supplicant MAC addresses for a dot1x profile represented with a
profile-name. You can configure up to 6 MAC addresses in a single mac command. The maximum number
of MAC addresses that you can configure in a single profile is limited to 100.
Use this command in Configuration Terminal Batch mode to configure a list of supplicant MAC addresses
for dot1x profile in a dual-homing setup.
Example
DellEMC(conf)#dot1x profile mySupplicants
DellEMC(conf-dot1x-profile)#mac 00:50:56:AA:01:10 00:50:56:AA:01:11
DellEMC(conf-dot1x-profile)#show config
dot1x profile mySupplicants
mac 00:50:56:aa:01:10
mac 00:50:56:aa:01:11
DellEMC(conf-dot1x-profile)#
DellEMC(conf-dot1x-profile)#exit
show dot1x cos-mapping interface
Display the CoS priority-mapping table the RADIUS server provides and applies to authenticated supplicants on an 802.1X-
enabled system.
Syntax
show dot1x cos-mapping interface interface [mac-address mac-address]
Parameters
interface Enter one of the following keywords and the interface information:
● For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
mac-address (Optional) MAC address of an 802.1X-authenticated supplicant.
Defaults None
178 802.1X