Administrator Guide

Version Description
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.2(0.2) Added support for IPv6.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Example
Following example shows that the VRF management is configured:
DellEMC#show ip vrf
VRF-Name VRF-ID Interfaces
default 0 Vl 1
management 512 Ma 1/1
Hence, the back-up destination command must be configured as:
DellEMC(conf-vlt-domain)#back-up destination <ip address> vrf management
vrf-name
clear vlt statistics
Clear the VLT operation statistics.
Syntax
clear vlt statistics [arp | domain | igmp-snoop | mac | multicast | ndp]
Parameters
domain Clear the VLT statistics for the domain.
multicast Clear the VLT statistics for multicast.
mac Clear the VLT statistics for the MAC address.
arp Clear the VLT statistics for ARP.
igmp-snoop Clear the VLT statistics for IGMP snooping.
ndp Clear the VLT statistics for NDP.
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
Virtual Link Trunking (VLT) 1641