Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

1621

To remove the limit on the maximum number of routes used, use the no maximum dynamic-routes

command.

Parameters

limit

Maximum number of routes allowed in a VRF. The valid range is from 1 to 16,000

(or maximum allowable for that platform if a smaller value).

warning-

threshold

The warning threshold value is a percentage of the limit value. When the number of

routes reaches the specified percentage of the limit, a warning message appears.

The valid range is from 1 to 100.

After the limit is reached, additional dynamic routes are not allowed.

warning-only When you use the warning-only option, when the maximum number of dynamic

routes reaches the limit, a warning message appears.

After the limit is reached, additional dynamic routes are still allowed.

Defaults No limit is set on the maximum number of dynamic routes for a VRF.

Command Modes

CONFIGURATION-VRF

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON and Z9500.

9.4(0.0) Introduced on the S–Series.

Usage

Information

If you do not specify the maximum route limit for a VRF, the VRF has unlimited space that extends to the

maximum number of entries allowed for the system.

show ip vrf

Displays information corresponding to the VRFs that you configure in the system.

Syntax

show ip [vrf vrf-name]

Parameters

vrf

vrf-name

Enter the keyword vrf then the name of the VRF to display information

corresponding to that VRF.

Command Modes

● EXEC

● EXEC Privilege