Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

1521

stack-unit provision

Preconfigure a logical stacking ID of a switch that joins the stack. This is an optional command that is executed on the

management unit.

Syntax

stack-unit [stack-number] provision {model-identifier}

Parameters

stack-number

Enter a stack member identifier of the switch that you want to add to the stack.

model-identifier

Enter the model identifier of the switch to be added as a stack member. This

identifier is also referred to as the provision type.

Defaults When this value is not set, a switch joining the stack is given the next available sequential stack member

identifier.

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.0) Introduced on the S6100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.7.0 Introduced on the S4810.

8.3.11.1 Introduced on the Z9000.

Commands

● reload – reboot the Dell EMC Networking OS.

● show system – display the status of all stack members or a specific member.

stack-unit stack-group

Configure the stacking unit and stacking group by specifying an ID when adding units to a stack to ensure the unit is assigned to

the correct group.

Syntax

stack-unit unit-id stack-group stack-group-id

To remove the current stack group configuration, use the no stack-unit unit-id stack-group

stack-id command.

Parameters

unit-id

Enter the stack unit ID.

stack-group-id

Enter the stack group ID.

Defaults none