Administrator Guide

show inventory
Display the switch type, components (including media), and Dell EMC Networking Operating System (OS), including hardware
identification numbers and configured protocols.
Syntax
show inventory [media slot]
Parameters
media slot (OPTIONAL) Enter the keyword media then the stack ID of the stack member for
which you want to display pluggable media inventory.
NOTE: This parameter is available but not supported in Dell EMC Networking
Operating System version 8.3.11.4. Because stacking is not supported, if you
use this parameter, the output displays “Media not present or accessible”
(refer to the Usage Information section).
Defaults none
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(0.0) Added support to display 10GBASE-T information on the S4048, S4048T, S6000,
S6000-ON, S6100, Z9500, S6010, and Z9100.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.4 Output expanded to include Piece Part ID (PPID) and eSR4 optics.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced this version of the command for S-Series. S-Series output differs from
E-Series.
Usage
Information
If there are no fiber ports in the unit, just the header under show inventory media displays. If there are
fiber ports but no optics inserted, the output displays Media not present or accessible.
Related
Commands
● show interfaces — displays the interface configuration.
Control and Monitoring 133