Administrator Guide

Version Description
7.4.1.0 and
6.5.3.0
Introduced on the E-Series.
Usage
Information
This command does not uniquely identify a queue, but rather identifies only a set of queues. The WRED
Curve is applied to all eight ingress Multicast queues.
NOTE: The multicast-bandwidth option is not supported on queue ingress. If you attempt to
use the multicast-bandwidth option, the following reject error message is generated: %
Error:Bandwidth-percent is not allowed for ingress multicast.
rate-police
Specify the policing functionality on incoming traffic.
Syntax
rate-police [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-
KB]]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps).
Make the following value a multiple of 64. The range is from 0 to 40000000. The
default granularity is Megabits per second (Mbps).
committed-rate Enter the bandwidth in Mbps. The range is from 0 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16 to 200000. The
default is 100.
peak peak-rate (OPTIONAL) Enter the keyword peak then a number to specify the peak rate in
Mbps. The range is from 0 to 40000. The default is the same as designated for
committed-rate.
Defaults Burst size is 100KB. peak-rate is by default the same as committed-rate. Granularity for
committed-rate and peak-rate is Mbps unless you use the kbps option.
Command Modes QOS-POLICY-IN
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
1244 Quality of Service (QoS)