Administrator Guide

Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced on the S3048-ON, S4048–ON, S4048T-ON, S6000–ON, S6100–ON,
and Z9100–ON
Usage
Information
Once you enter reload-type, you need to enter the boot-type required on the next reboot. After
configuring boot-type you need to save the configuration with the write cli to make it active.
Example
DellEMC(conf-reload-type)#boot-type warmboot
DellEMC(conf-reload-type)#end
Dell#
secure-erase
Allows you to perform an fstrim on the flash disk during the next reload.
Syntax
secure-erase
To disable secure-erase, use the no secure-erase command.
Defaults Enabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(2.6) Introduced on the S3048-ON, S4048–ON, S4048T-ON, S6000–ON, S6100–ON,
and Z9100–ON
Usage
Information
Since secure-erase is enabled by default, once you enter reload-type, you need to enter the no
secure-erase command to disable it on the next reboot.
Example
DellEMC(conf-reload-type)#no secure-erase
DellEMC(conf-reload-type)#end
DellEMC#
send
Send messages to one or all terminal line users.
Syntax
send [*] | [line ] | [console] | [vty]
Parameters
* Enter the asterisk character * to send a message to all tty lines.
line Send a message to a specific line. The range is from 0 to 11.
console Enter the keyword console to send a message to the primary terminal line.
vty Enter the keyword vty to send a message to the virtual terminal.
Defaults none
Command Modes EXEC
Control and Monitoring 123