Administrator Guide

Example
The following example shows how to reload the system:
DellEMC# reload
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into Dell diagnostics mode:
DellEMC#reload dell-diag
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into ONIE mode:
DellEMC#reload onie
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into ONIE prompt and enter the install mode
directly:
DellEMC#reload onie install
Proceed with reload [confirm yes/no]: yes
reload-type
Allows you to configure the boot-type or secure-erase for the next reload.
Syntax
reload-type
Parameters N/A
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced on the S3048-ON, S4048–ON, S4048T-ON, S6000–ON, S6100–ON,
and Z9100–ON
Usage
Information
Once you enter reload-type, you need to enter the boot-type or secure-erase sub-command
required on the next reboot.
Example
DellEMC(conf)#reload-type
DellEMC(conf-reload-type)#boot-type fastboot
DellEMC(conf-reload-type)#end
Dell#
boot-type
Allows you to configure the boot-type for the next reload.
Syntax
boot-type bmp-reload| fastboot| normal-reload| warmboot
Parameters
bmp-reload Reloads using the bare metal provisioning mode
fastboot Reloads using the fastboot mode
normal-reload Reloads using the standard, manual interactive mode
warmboot Reloads using the warmboot mode
Defaults normal-reload
122 Control and Monitoring