Administrator Guide

● For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a port-channel interface, enter the keywords port-channel then the
port-channel ID.
● For a VLAN, enter the keyword vlan then a number from 1 to 4094.
priority (OPTIONAL) Enter the priority used in RP election process. The range is zero (0)
to 255. The default is 192. In the RP election process, the RP with the lower
priority takes the precedence.
acl-name (OPTIONAL) Enter the name of an ACL to configure a PIM router to act as an RP
for a specific set of multicast group addresses that are defined in the ACL.
NOTE: If you do not specify the acl-name, the system uses the default
multicast IPv6 group range, which is ff00::/8.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(1.0) Introduced on the C9010, S3048–ON, S3100 Series, S4048–ON, S4048T–ON,
S6000–ON, S6010–ON, S6100–ON, Z9100–ON.
Usage
Information
Priority is stored at BSR router when receiving a Candidate-RP-Advertisement.
ipv6 pim sparse-mode
Enable IPv6 PIM sparse mode and MLD on the interface.
Syntax
ipv6 pim sparse-mode
To disable IPv6 PIM sparse mode and MLD on the interface, use the no ipv6 pim sparse-mode
command.
Defaults Disabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11.3.0 Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON,
S3100, S6010-ON, S3048-ON, and C9010.
Usage
Information
Enable the interface (use the no shutdown command) and not have the switchport command
configured. Also enable Multicast globally. PIM is supported on the port-channel interface.
1182 PIM-Sparse Mode (PIM-SM)