Reference Guide

3 Set the scheduler as the strict priority in POLICY-MAP-CLASS-MAP mode.
priority
4 Save the conguration.
do commit
Apply policy-map
1 You can now apply the policy-map to the interface (INTERFACE mode) or all interfaces—SYSTEM-QOS mode.
system qos
OR
interface ethernet node/slot/port[:subport]
2 Enter the output service-policy in SYSTEM-QOS mode or INTERFACE mode.
service-policy {output} type {queuing} policy-map-name
3 Save the conguration.
do commit
Enable strict priority on class-map
OS10(config)# class-map type queuing magnum
OS10(conf-cmap-queuing)# match queue 7
OS10(conf-cmap-queuing)# exit
OS10(config)# policy-map type queuing solar
OS10(conf-pmap-queuing)# class magnum
OS10(conf-pmap-c-que)# priority
OS10(conf-pmap-c-que)# exit
OS10(conf-pmap-queuing)# exit
OS10(config)# system qos
OS10(conf-sys-qos)# service-policy output solar
OS10(conf-sys-qos)# do commit
View QoS system
OS10(conf-sys-qos)# do show qos system
Service-policy (output)(queuing): solar
Enable strict priority on interface
OS10(config)# interface ethernet 1/1/5
OS10(conf-if-eth1/1/5)# service-policy output type queuing solar
OS10(conf-if-eth1/1/5)# do commit
View policy-map
OS10(conf-if-eth1/1/5)# do show policy-map
Service-policy(queuing) output: solar
Class-map (queuing): magnum
priority
Class of service or dot1p classication
Classication allows you to manage network trac by separating it into dierent categories. Packets are identied and categorized into
trac classes. You can use the match command to apply a match to place network trac into specic trac classes.
You can classify the QoS trac based on class of service (CoS) or 802.1 p (dot1p) values. You cannot have two match statements with the
same match criterion. If you enter two match statements with the same match criterion, the second statement overwrites the rst
statement.
1 Create a class-map and qos type in CONFIGURATION mode.
class—map type qos class—map-name
Quality of service
451