Reference Guide

• 00:00:00:00:00:00 — (Optional) Enter which bits in the MAC address must match. If you do not enter a
mask, a mask of 00:00:00:00:00:00 applies.
• any — (Optional) Set all routes which are subject to the lter:
• protocol-number — Protocol number identied in the MAC header (600 to ).
• capture — (Optional) Capture packets the lter processes.
• cos — (Optional) CoS value (0 to 7).
• count — (Optional) Count packets the lter processes.
• byte — (Optional) Count bytes the lter processes.
• vlan — (Optional) VLAN number (1 to 4094).
Default Not congured
Command Mode CONFIG-MAC-ACL
Usage Information OS10 cannot count both packets and bytes — when you enter the count byte options, only bytes increment.
Use the no version of this command to remove the lter, or use the no seq sequence-number command if
you know the lter’s sequence number.
Example
OS10(config)# mac access-list macacl
OS10(conf-mac-acl)# seq 10 deny 00:00:00:00:11:11 00:00:11:11:11:11 any cos 7
OS10(conf-mac-acl)# seq 20 deny 00:00:00:00:11:11 00:00:11:11:11:11 any vlan 2
Supported Releases 10.2.0E or later
seq deny icmp
Assigns a lter to deny internet control message protocol (ICMP) messages while creating the lter.
Syntax
seq sequence-number deny icmp [A.B.C.D | A.B.C.D/x | any | host ip-address]
[A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | count [byte] | dscp
value| fragment]
Parameters
• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing
number (0 to 4294967295).
• A.B.C.D — Enter the IP address in dotted decimal format.
• A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.
• any — (Optional) Set all routes which are subject to the lter:
• capture — (Optional) Capture packets the lter processes.
• count — (Optional) Count packets the lter processes.
• byte — (Optional) Count bytes the lter processes.
• dscp value — (Optional) Deny a packet based on the DSCP values (0 to 63).
• fragment — (Optional) Use ACLs to control packet fragments.
• host ip-address — (Optional) Enter the IP address to use a host IP address only.
Default Not congured
Command Mode IPV4-ACL
Usage Information OS10 cannot count both packets and bytes — when you enter the count byte options, only bytes increment.
Use the no version of this command to remove the lter, or use the no seq sequence-number command if
you know the lter’s sequence number.
Access Control Lists 415