Reference Guide

Checksum: 0xAB87
Length: 28
Network Mask: /24
TOS: 0 Metric: 1
Supported Releases 10.2.0E or later
show ip ospf interface
Displays the congured OSPF interfaces. You must enable OSPF to display output.
Syntax show ip ospf interface [process-id]interface or show ip ospf [process-id]
interface [interface]
Parameters
• process-id — (Optional) Displays information for an OSPF Process ID. If you do not enter a Process ID, this
command applies only to the rst OSPF process.
• interface — (Optional) Enter the interface information:
• ethernet — Enter the Ethernet interface information (1 to 48)
• port channel — Enter the port-channel interface number (1 to 128).
• vlan — Enter the VLAN interface number (1 to 4094).
Default Not congured
Command Mode EXEC
Example
OS10# show ipv6 ospf interface
ethernet1/1/1 is up, line protocol is up
Link Local Address fe80::20c:29ff:fe0a:d59/64, Interface ID 5
Area 0.0.0.0, Process ID 200, Instance ID 0, Router ID 10.0.0.2
Network Type broadcast, Cost: 1
Transmit Delay is 1 sec, State BDR, Priority 1
Designated Router on this network is 2.2.2.2
Backup Designated router on this network is 10.0.0.2 (local)
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 2.2.2.2(Designated Router)
Supported Releases 10.2.0E or later
show ip ospf statistics
Displays the OSPF statistics information.
Syntax
• show ip ospf [process-id] statistics interface [interface]
•
show ip ospf [process-id] statistics [interface]
Parameters
• process-id — (Optional) Displays OSPF process information. If you do not enter a process ID, the rst
OSPF process displays. If you do not enter a Process ID, this command applies only to the rst OSPF process.
• interface — (Optional) Enter the interface type and information or number:
• ethernet — Physical interface (1 to 48)
• port-channel — Port-channel interface (1 to 128).
298 Layer 3