Reference Guide
Example
OS10(conf-if-eth1/1/1)# spanning-tree msti 1 priority 0
OS10(conf-if-eth1/1/1)# spanning-tree msti 1 cost 3
Supported Releases 10.2.0E or later
spanning-tree port
Sets the port type as the EdgePort.
Syntax
spanning-tree port type edge
Parameters None
Default Not congured
Command Mode INTERFACE
Usage Information When you congure an EdgePort on a device running STP, the port immediately transitions to Forwarding state.
Only congured ports connected to end hosts act as EdgePorts.
Example
OS10(config)# spanning-tree port type edge
Supported Releases 10.2.0E or later
Rapid per-VLAN spanning-tree plus
RPVST+ is an RSTP to create a single topology per VLAN. RPVST+ is enabled by default, provides faster convergence, and runs on the
default VLAN (VLAN 1).
Conguring Rapid-PVST+ is a four-step process:
1 Ensure the interfaces are in L2 mode.
2 Place the interfaces in VLANs. By default, switchport interfaces are members of the default (VLAN1).
3 Enable Rapid-PVST+ (only required if another variation of STP is present).
4 (Optional) Select a non-default bridge-priority for the VLAN for load balancing.
154
Layer 2