Reference Guide

• vlan range — Enter a VLAN range value (1 to 4094).
Default Not congured
Command Mode MULTIPLE-SPANNING-TREE
Usage Information By default, all VLANs map to MST instance zero (0) unless you are using the vlan range command to map the
VLANs to a non-zero instance. The no version of this command removes all the instance related conguration.
Example
OS10(conf-mst)# instance 1 vlan 2-10
OS10(conf-mst)# instance 2 vlan 11-20
OS10(conf-mst)# instance 3 vlan 21-30
Supported Releases 10.2.0E or later
name
Assigns a name to the MST region.
Syntax
name region-name
Parameters region-name — Enter a name for an MST region (up to 32 characters).
Default System MAC address
Command Mode MULTIPLE-SPANNING-TREE
Usage Information By default, MST protocol assigns system MAC as the region name. Two MST devices within the same region must
share the same region name, including matching case.
Example
OS10(conf-mst)# name my-mst-region
Supported Releases 10.2.0E or later
spanning-tree mst conguration
Enters MST mode to congure MSTP from Conguration mode.
Syntax
spanning-tree mst configuration
Parameters None
Default Disabled
Command Mode CONFIGURATION
Usage Information Use this command to enter STP MST conguration mode.
Example
OS10(config)# spanning-tree mst configuration
OS10(conf-mst)#
Supported Releases 10.2.0E or later
revision
Congures a revision number for the MSTP conguration.
Syntax
revision number
148 Layer 2