Reference Guide

Default Not congured
Command Mode INTERFACE
Usage Information The only valid value is Compellant in this release. Congure directly attached storage arrays to be supported by
iSCSI if they are not automatically detected. This command is required for storage devices that do not support
LLDP. The no version of this command disables the connection.
Example
OS10(conf-if-eth1/1/2)# iscsi profile-storage compellant
Supported Releases 10.3.0E or later
iscsi session-monitoring enable
Enables iSCSI session monitoring.
Syntax
iscsi session-monitoring enable
Parameter None
Default Disabled
Command Mode CONFIGURATION
Usage Information Use the iscsi aging time command to congure the aging timeout in iSCSI monitoring sessions, and use the
iscsi target port command to congure the TCP ports that listen for connected storage devices in iSCSI
monitoring sessions. The
no version of this command disables iSCSI session monitoring.
Example
OS10(config)# iscsi session-monitoring enable
Supported Releases 10.3.0E or later
iscsi target port
Congures the TCP ports used to monitor iSCSI sessions with target storage devices.
Syntax
iscsi target port tcp-port1 [tcp-port2, ..., tcp-port16] [ip-address ip-
address]
Parameters
• tcp-port — Enter one or more TCP port numbers (0 to 65535). Separate TCP port numbers with a comma.
• ip-address ip-address — (Optional) Enter the IP address in A.B.C.D format of a storage array whose
iSCSI trac is monitored on the TCP port.
Default 3260,860
Command Mode CONFIGURATION
Usage Information You can congure up to 16 TCP ports to monitor iSCSI trac from target storage devices. The no version of this
command including the IP address removes a TCP port from iSCSI monitoring.
Example
OS10(config)# iscsi target port 26,40
Supported Releases 10.3.0E or later
564 Converged data center services