Reference Guide

set comm-list delete
Remove communities in the specied list from the COMMUNITY attribute in a matching inbound or outbound BGP route.
Syntax
set comm-list {community-list-name} delete
Parameters community-list-name — Enter the name of an established community list. A maximum of 140 characters.
Defaults None‘
Command Mode ROUTE-MAP
Usage Information
The community list you use in the set comm-list delete command must be congured so that each lter
contains only one community. For example, the lter deny 100:12 is acceptable, but the lter deny 120:13
140:33
results in an error. If you congure the set comm-list delete command and the set community
command in the same route map sequence, the deletion command (set comm-list delete) processes
before the insertion command (set community). To add communities in a community list to the COMMUNITY
attribute in a BGP route, use the set comm-list add command.
Example
OS10(config)# route-map bgp
OS10(conf-route-map)# set comm-list comlist1 delete
Supported Releases 10.3.0E or later
set community
Sets the community attribute in BGP updates.
Syntax
set community {none | community-number}
Parameters
• none — Enter to remove the community attribute from routes meeting the route map criteria.
• community-number — Enter the community number in aa:nn format, where aa is the AS number (2
bytes) and
nn is a value specic to that AS.
Default Not congured
Command Mode ROUTE-MAP
Usage Information The no version of this command deletes a BGP COMMUNITY attribute assignment.
Example
OS10(config)# route-map bgp
OS10(conf-route-map)# set community none
Supported Releases 10.3.0E or later
set extcomm-list delete
Remove communities in the specied list from the EXT COMMUNITY attribute in a matching inbound or outbound BGP route.
Syntax
set extcomm-list extcommunity-list-name delete
Access Control Lists 467