Users Guide

show ipv6 neighbors
Display IPv6 discovery information. Entering the command without options shows all IPv6 neighbor addresses stored on the control
processor (CP).
Syntax
show ipv6 neighbors [vrf vrf-name] [ipv6-address| interface interface]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to display the
neighbors corresponding to that VRF.
NOTE: If you do not specify this option, neighbors corresponding to the
default VRF are displayed.
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x format.
NOTE: The :: notation species successive hexadecimal elds of zero.
interface interface Enter the keyword interface then the interface type and slot/port or number
information:
• For a port channel interface, enter the keywords port-channel then a
number.
•
For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a Management interface, enter the keyword managementethernet followed
by slot/port numbers. The port is 0.
• For a Port Channel interface, enter the keywords port-channel followed by a
number from 1 to 128.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Neighbor Discovery Protocol (NDP)
997